Buzz 230 - 7in FPV Quadcopter - 5mm Countersunk Edition
This particular model is cut to order - please contact us for ordering
230mm size quadcopter frame - one piece / 5mm thick CF
Countersunk Flight Controller mounts
Countersunk PDB mounts (can also be a 1.5mm CF FC topplate if no PDB is used)
Results in a flush frame with Flight Controller and PDB embedded into the carbon fiber. This is perfect for extremely low profile/minimal/lightweight builds. The only thing that will be sticking out of the frame will be the FC pins (if used and not direct soldered), and a Rx.
ESC's mounted on arm, with slots allowing rerouting to bottom or top for PDB/wiring.
Motor mount slots are 16-19mm - allowing 22xx sized motors with 5, 6, and 7inch props! Powerhouse
The top FPV pod allows an hs1177 type camera (SONY mini super had ii CCD) to be tilted up to a 50 degree angle without any obstruction.
This design provides the least amount of drag possible in a racing quadcopter of this size by incorporating the top stack and fpv pod.
The FPV pod allows 3 mounting options for your vtx antenna: Direct mounting as shown below, pigtail mounting, and straight antenna with protection mounting.
Countersunk version shown except in renderings